2014 Jeep Wrangler JK Rubicon on 39s, stretched, 1 tons, 16k miles
Posted
$44,000
Rancho Cucamonga, CA
Overview
Year, Make, Model
2014 Jeep Wrangler JK Rubicon
Link
https://inlandempire.craigslist.org/cto/d/rancho-cucamonga-1-of-kind-jeep-jk/7120948087.htmlMiles
16,100
Posted
Engine
Engine
V6
Fueling
Gas, EFI
Drivetrain
Transmission
manual
Transfer Case
Rubicon
Front Axle
Dana 60, 5.38, ARB Air Locker, 35 spline chromoly shafts
Rear Axle
14 bolt, 5.38, Detroit Locker, chromoly shafts
Suspension and Steering
Front Suspension
Custom 3 link, Evo Doublethrown Kit
Rear Suspension
Custom 4 link, King 2.5 Coilovers
Steering
high steer, PSC and West Texas Offroad components
Tires and Wheels
Tires
39" Toyo Race, 80% tread
Wheels
BTR forged beadlocks
- Priced to sell
- Over 70k invested
- 2014 Jeep JK 2 door
- Built by Jubera Fab
- 2014 Rubicon 3.6 16k miles
- Full working ABS and speedo no Christmas tree dash
- Full cage welded into frame
- VKS bumpers and welded sliders
- Poison Spyder front fenders and custom corners
- Backhalfed rear with custom 4 link
- 6” rear stretch
- 2.5 coil over and 2.0 bump tabbed for bypass
- Sealed cabin
- 37 gallon fuel cell
- Custom 3 link front
- 3” front stretch
- 2.0 coil over, 2.5 bypass, 2.0 bump stops
- Fully built 1 Ton axles
- Upgraded brakes and PSC steering
- 39” toyo tires on BTR beadlocks
- Prp seats and harnesses
- Race radio/ intercom with headsets
- Lights all around plus switch pros controller
- Lots of extras and things I’m forgetting
- Just paid reg, good until March 2021
- Asking 44k obo please make offer
- Full build is on @trophy_jk on instagram
Exterior Parts
- VKS Prerunner front bumper
- VKS custom rear bumper
- VKS custom sliders
- VKS a pillar light bar mounts included
- Custom rear corners with frenched fuel filler and rear led lights/led reverse
- Ace license plate mount
- EVO inner fenders
- Custom 3D Printed radio antenna mount
- 37 gallon fuel cell with factory sending unit and pump
Lights
- Front bumper 20” bar
- Two a pillar pods
- Upgraded led headlights
- Rear 10” 50⁄50 clear/amber bar for reverse and dust light
- Rock lights on bottom and wheel wells
Interior
- Solid state controller for all electronics
- Arb compressor
- Rugged Radios intercom/race radio
- Led interior lights wired to factory switch
- PRP seats on sliders with 5 point harnesses
- CMM billet grab bar with misc RAM mounts
Fabrication
- Full 4130 Chromoly cage and rear tube work welded directly to frame.
- Frame was cut 3” after doors and tube chassis after that.
- Sealed cabin
Front Axle
- Dana 60 with bottom truss
- Arb locker 5.38 gears
- Chromo inner and outer shafts 35 spline
- Currie billet unit bearings with abs sensors
- RPM Offroad drive slugs
- Arb diff cover
- Weaver Fab high steer kit
- Upgraded brakes with rotors, calipers, and pads
Front Suspension
- Evo doublethrown kit with custom valving in all 4 shocks and different pistons.
- King 2.0 bumpstops
- Kartek limit straps
- Custom made 3 link with chromoly links and Johnny Joints at every end
- Custom Chromoly steering and track bar with FK heims
Rear Axle
- AAM 14 bolt
- Upgraded brakes
- Chassis Unlimited diff cover
- Chromo shafts
- Detroit locker 5.38 gears
- Custom hubs with ABS
- Artec Truss
Rear Suspension
- King 2.5 coil overs with custom valving by Dialed Shock Prep
- King 2.0 bump stops
- Kartek limit straps
- Tabbed and ready for up to a 3.5” bypass in rear. Can include and install for additional cost
- Custom made 4 link with chromoly links and Johnny Joints at every end
- Custom sway bar with FK heims
Wheels/Tires
- BTR forged beadlocks
- 39” toyo race tires with 80 percent tread
- 1 spare black recline beadlock with same tire
Under Hood
- PSC high flow steering pump
- PSC steering Cooler
- PSC steering resivoir
- West Texas Offroad steering box with ram ports
- Upgraded master cylinder/brake booster
- Vac pump relocation
- KN filter washable
- True dual magnaflow mufflers with turn downs